Enterasys-networks VSER-RPU-SYS Manual de usuario descargar pdf (Pagina 19)

Connecting Switches to the RPS

2-5

Desktop or Shelf Mounting

1. Attach the four adhesive feet to the bottom of the first RPS unit.

Figure 2-3. Attaching the Adhesive Feet

2. Set the device on a flat surface near an AC power source, making sure there

are at least two inches of space on all sides for proper air flow.

Connecting Switches to the RPS

Caution: DO NOT connect the RPS to an AC power source until DC power cords have

been connected to the supported switches.

To connect switches to the RPS, refer to Figure 2-4 and Figure 2-5 and proceed as

follows:

1. Power up the switch by connecting one end of the AC cord to the AC receptacle

on the supported switch, and the other end to a grounded power outlet.

Figure 2-4. Power Receptacle

2. Connect one end of a DC cord to the redundant power receptacle on the

supported switch and the other end to an available receptacle on the RPS.

3. Repeat steps 1 and 2 for connecting up to four supported switches to the RPS.

Rear

anel

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Sin comentarios

Enterasys-networks VSER-RPU-SYS Manual de usuario Pagina 19