Enterasys Networks G3G124-24 Manual de usuario descargar pdf (Pagina 47)

Checking the LEDs

Enterasys G-Series Hardware Installation Guide 3-3

Power LEDs

ThetwopowerLEDs,markedPWR1andPWR2,indicatevoltagefortheprimaryandsecondary

powerinputs.Table 3‐2describestheirstatus.

IOM Status LEDs

ThethreeIOMstatusLEDs,markedPOWEROFF‐SLOT2,SLOT3,andSLOT4,indicate

operationalstatusofinstalledmodulesasdescribedinTable 3‐3.

Fixed and IOM Port LEDs

Table 3‐4describesthestatusofRJ45and comboSFPportLEDsintheG‐Seriesfixedfrontpanel

andinstalledIOM(s).

Table 3-2 Power LED Definitions

Display Status

Off Power supply not present.

Green Normal operation.

Amber Not enough power for redundancy. Operating in additive power mode.

Red Power failure.

Table 3-3 IOM Status LED Definitions

Display Status

Off IOM module not present, or IOM(s) installed without. system reboot.

Solid Green Normal operation.

Blinking Green Booting up / shutting down.

Amber Safe to remove module. Refer to “Removing an IOM” on page 2-11 for correct

procedure.

Red Power failure.

Table 3-4 Port LED Definitions

Display Status

Off No link established.

Solid Green Ethernet link established without activity. For combo SFP ports, this indicates

power up.

Blinking Green Ethernet link established with activity.

Solid Amber

(RJ45 only)

Link established without activity and failure to provide power to powered devices.

For RJ45 ports, this indicates power up.

Blinking Amber

RJ45 only)

Link established with activity and failure to provide power to powered devices.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 58 59

Sin comentarios

Enterasys Networks G3G124-24 Manual de usuario Pagina 47