Enterasys-networks Enterasys Gold Distributed Forwarding Engine 4H428 Manual de usuario descargar pdf (Pagina 82)

Memory Locations and Replacement Procedures

B-8 Mode Switch Bank Settings and Optional Installations

2. RefertoFigure B‐9.Pushtheconnectorarmsawayfromthe memorymoduleto

releaseitfromtheconnector.

3. Removethemodulefromtheconnector.

Installing the DRAM SIMM on 4H4282-49 or 4H4283-49

Toinstallthememorymodule,refertoFigure B‐10andproceedasfollows:

1. Withtheconnectorarmssetintheopenposition,insertthememorymodulebetween

theconnectorfingersandpushthememorymoduleintotheconnectoruntilthetabs

onthetwoconnectorarmspullintowardstheDRAM

SIMMalignmentnotches.

2. PushtheDRAM SIMMfurtherintotheconnectoruntilthetwoalignmentnotchesand

thetabsonthetwoconnectorarmslocktheDRAMSIMMintoplace.

Note: The ejector arms on this connector are not spring loaded, so they will remain in the

open position until manually closed.

Figure B-9 Removing the Existing DRAM SIMM from 4H4282-49 or 4H4283-49

1 Connector arms 2 Memory module 3 Connector

Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive

electronic equipment.

Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones

de seguridad para evitar descargas de electricidad estática.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 88 89 90

Sin comentarios

Enterasys-networks Enterasys Gold Distributed Forwarding Engine 4H428 Manual de usuario Pagina 82