Enterasys-networks Enterasys Platinum Distributed Forwarding Engine 7 Manual de usuario Pagina 64

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 96
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 63
Using LANVIEW
4-6 Troubleshooting
RX/TX Indications in Standard Mode
RX
(Receive)
Off No link. No activity. Port
enabled or disabled.
None.
Green Solid. Link present, port
enabled, no traffic is being
received by the interface.
None.
Amber Flashing. Link present, port
enabled, traffic is being
received by the interface.
None.
Red Blinking. Indicates
collisions. This indication is
only supported on 10/100
ports.
Contact Enterasys Networks for
technical support.
TX
(Transmit)
Off Port enabled, but no activity. If it is known that the port should be
active and is not, contact
Enterasys Networks for technical
support.
Green Flashing. Indicates data
transmission activity. Rate of
flashing indicates the data
rate.
None.
Red Flashing. Fault or Error
(collision).
None, unless there is a high rate of
activity. In this case, check for network
configuration problems or a defective
device.
Table 4-1 LANVIEW LEDs (continued)
LED Color State Recommended Action
Vista de pagina 63
1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 95 96

Comentarios a estos manuales

Sin comentarios