Enterasys-networks 8000/8600 Manual de usuario descargar pdf (Pagina 96)

Installing a PCMCIA Flash Card

84 Enterasys X-Pedition 8000/8600 Getting Started Guide

Installing a PCMCIA Flash Card

The control module PCMCIA flash card contains a version of the system image software that is

installed at the factory. If you have a more recent system image and want to boot the X-Pedition

using the newer software, you must boot either from a PCMCIA card or from a TFTP server.

To install a PCMCIA card:

1. Power off the X-Pedition.

Cautions: Do NOT install or remove a PCMCIA card while the X-Pedition is running.

2. Insert the PCMCIA card into the upper slot on the control module, pressing firmly to ensure

that the card is fully seated.

Figure 36. Install a PCMCIA flash card in a Control Module

Note: Only the upper slot is active. The control module cannot use two PCMCIA flash cards at

the same time.

3. Lock the PCMCIA card into the slot with the locking mechanism.

4. Power on the X-Pedition. (See Powering On and Booting the Software on page 86.)

5. Once the X-Pedition is powered on and starts to boot up, any of the following scenarios may

occur:

Console

10/100 Mgmt

SSR-CM4-256

ONT

ROL!MODULE

nsert

This sid

e up

PART NO.

478

ftwar

DEL

NO.

P-

A-32

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 141 142

Sin comentarios

Enterasys-networks 8000/8600 Manual de usuario Pagina 96