Enterasys-networks C2RPS-SYS Manual de usuario descargar pdf (Pagina 23)

SecureStack C2 Installation Guide 2-1

Installation

Thischapterprovidestheinstallat ioninstructionstoinstallallthecomponentsofanRPS.

TocorrectlyinstallanRPS,followtheorderofinformationlistedbelow.

Required Tools

Aflat‐bladescrewdriverisrequiredtoinstalltheC2RPS‐CHAS8andC2RPS‐PSMs.

Unpacking Chassis and Power Supply Module(s)

TheC2RPS‐CHAS8andC2RPS‐PSMareshippedseparately.Tounpackthesedevices

proceedasfollows:

1. Opentheboxandremovethepackingmaterialprotectingthedevices.

2. Verifythecontentsofeachcartonandcomparethecontentsshippedwiththoselisted

inTable 2‐1andTable 2‐2.

Electrical Hazard: Only qualified personnel should perform installation procedures.

Advertencia eléctrica: Solamente personal calificado debe realizar procedimientos de

instalacion.

Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und

qualifiziertes Personal vorgenommen werden.

For information about... Refer to page...

Required Tools 2-1

Unpacking Chassis and Power Supply Module(s) 2-1

Installing C2RPS-PSMs 2-2

Installing C2RPS-CHAS8 into the Rack 2-4

Connecting the PSM Cables and AC Power Cords 2-6

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 33 34

Sin comentarios

Enterasys-networks C2RPS-SYS Manual de usuario Pagina 23