Enterasys-networks C2RPS-SYS Manual de usuario descargar pdf (Pagina 26)

Installing C2RPS-CHAS8 into the Rack

2-4 Installation

3. PullthePSMoutandremoveitfromthechassis.

4. Repeatsteps1through3foreachadditionalPSMyouplantoremove.

ToinstallaPSM,proceedasfollows:

1. AlignthePSMwiththeslot,thenslidethePSMforwarduntilitsfrontpanelisflush

againstthechassisfrontpanel.

2. FastenthePSMtothechassisusingthecaptive

screws.

3. Performsteps1and2foreachPSMbeingreplaced.Whencompleted,proceedto

“ConnectingthePSMCablesandACPowerCords”onpage 2‐6.

Installing C2RPS-CHAS8 into the Rack

Toinstallthe chassisintoa19‐inchrack,youneedtenuser‐suppliedscrewstofastenthe

chassistotherackrails.

AfterinstallingthePSM(s)asdescribedbackin“InstallingC2RPS‐PSMs”onpage 2‐2,

rackmountthechassisasfollows:

1. Refertotheinstallationguidelines(“Guidelinesfor

RackmountInstallation”on

page 2‐4).

2. Installthechassisintotherack(“Rack MountingtheChassis”onpage 2‐5).

3. ConnectthePSMcablesandACpowercords(“ConnectingthePSMCablesandAC

PowerCords”onpage 2‐6).

Guidelines for Rackmount Installation

Theinstallationsitemustbewithinreachofthenetworkcablingandmeetthe

requirementslistedbelow:

•Chassisplacementcloseenoughtoconnectthe2‐meter(6.6‐foot)PSMcablesfromthe

PSMstotheACpowersource.

•Uptoeightthree‐prongedpowerreceptaclescapableofdeliveringthecurrentand

voltage

specifiedin“C2RPS‐PSMSpecifications”onpage A‐2.UptoeightACoutlets

onindependently‐fusedcircuitsmustbewithin182 centimeters(6 feet)fromthe

installationsite.IfthereisanACpowersourcefailure,thiswillpreventthepowering

downofPSMsduetoasinglesourcepowerfailure.

•Power

cordsandtypeofoutletaredependentonthecountry.IntheUnitedStates,

onepowercordwithanNEMA5‐15PplugisprovidedwitheachC2RPS‐PSM.

Note: If you plan to remove and not replace a C2RPS-PSM, immediately reinstall

coverplates over any empty power supply slots to prevent EMI leakage from the chassis.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32 33 34

Sin comentarios

Enterasys-networks C2RPS-SYS Manual de usuario Pagina 26