Enterasys-networks XSR-3020 Manual de usuario Pagina 23
- Pagina / 110
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
System Description
XSR Getting Started Guide 1-3
Figure 1-2 XSR-3020
• Two Network Interface Module (NIM) slots for these optional cards:
• 1, 2, or 4 full, fractional and channelized T1/E1 WAN NIM with integral CSU/DSU or
Primary Rate Interface (PRI) ports (RJ-48C).
• 1-port T3/E3 channelized/unchannelized WAN NIM with BNC ports. This NIM is also
available with up to 16 T1/E1 tributaries and system synchronization of two NIMs.
• High-speed serial port for up to 230 Kbps asynchronous and 8 Mbps synchronous WAN
NIM for leased and dial lines (68-pin serial) with universal connector supporting X.21, V.35,
RS422 and EIA530.
• 1- or 2-port serial Basic Rate Interface (BRI) WAN NIM for S/T (RJ-45) or U ports (RJ-49C).
• 1-port Annex A (POTS)/C or B (ISDN) ADSL WAN NIMs with RJ-11 connector with
CompactFlash card.
• 2-port T1/E1 Drop and Insert WAN NIM with RJ-45 connectors.
• 1-port Copper or Fiber Ethernet LAN or WAN NIM with an RJ-45 or MT-RJ multi-mode
interface.
• Three 10/100/1000BaseT GigabitEthernet LAN connectors and a Mini-Gigabit Interface
Converter (MGBIC) fiber-optic port capable of operating in full or half-duplex modes.
• COM (console) serial interface including modem control signals for remote debugging, or out-
of-band configuration
• 128 MBytes of 64-bit, 133 MHz SDRAM/DIMM memory, 8 MBytes of Onboard Flash RAM,
optional 16 MByte plug-in CompactFlash RAM card upgradeable to 1 GByte for firmware,
image and alarm storage.
• PCI-based, Encryption Module hardware accelerator for: encryption/decryption (3DES),
Message Digest (MD-5, SHA-1), and public key acceleration.
• Alarm detection, local and remote loopback, and loopback tests.
N
IM
1
N
IM
2
1
00
0
G
B
IC
L
in
k
T
X
10
/1
00
/1
0
0
0
1
0
/10
0
/10
00
SEC
U
RITY
R
O
UTE
RS
XSR-3020
C
O
M
PW
R
S
Y
S
N
IM
1
N
IM
2
V
P
N
COM
ETH3
ETH2ETH1
- X-Pedition 1
- Security Router 1
- Industry Canada Notices 5
- Class A ITE Notice 5
- Clase A. Aviso de ITE 5
- Klasse A ITE Anmerkung 5
- orcontact 6
- (Circuit Modules) 7
- (Circuit Breakers) 7
- VCCI Notice 8
- BSMI EMC Statement — Taiwan 8
- Declaration of Conformity 8
- Australian Telecom 9
- Contents 13
- Appendix A: Specifications 15
- About This Guide 17
- Getting Help 19
- Overview 21
- PSTN (for PPP) 22
- ETH2ETH1 23
- Operating System 24
- Industry-common CLI 24
- IP Protocol 24
- IP Routing 25
- SNMP and Statistics Gathering 25
- Security 26
- Frame Relay 26
- System Description 27
- XSR Getting Started Guide 1-7 27
- Quality of Service (QoS) 28
- Virtual Private Network (VPN) 28
- GRE over IPSec 29
- Dial Service 30
- Dial Backup 30
- Installation Overview 31
- 1-12 Overview 32
- Hardware Installation 33
- 2-2 Hardware Installation 34
- XSR Getting Started Guide 2-3 35
- 2-4 Hardware Installation 36
- XSR Getting Started Guide 2-5 37
- 2-6 Hardware Installation 38
- Connecting Cables 39
- SECURITY ROUTERS 40
- XSR Getting Started Guide 2-9 41
- Figure 2-16 42
- Figure 2-18, respectively 43
- Software Configuration 44
- Initializing XSR Software 46
- 3-2 Software Configuration 46
- XSR Getting Started Guide 3-3 47
- Setting the Clock 51
- Configuring the LAN Ports 52
- Configuring the WAN Ports 52
- BRI Leased Line 53
- BRI Leased Frame Relay 53
- BRI Switched Line 54
- Firewall Sample Configuration 56
- Setting Up RIP Routing 58
- Configure OSPF Routing 59
- 3-16 Software Configuration 60
- Viewing Your Configuration 61
- 3-18 Software Configuration 62
- Site regional router 64
- Configure Users and Passwords 66
- Configure LAN Interface 66
- Configure Quality of Service 66
- Apply QoS 68
- Configure More Access Lists 68
- Configure DHCP/BOOTP Relay 69
- Configure SNMP 70
- Set Up IKE Phase I Security 71
- Create a Transform Set 72
- Configure Crypto Maps 72
- 3-30 Software Configuration 74
- XSR Rebooting Characteristics 76
- Reboot Triggers 77
- Cause Boot Type 77
- 3-34 Software Configuration 78
- Bootrom Monitor Mode Commands 79
- 3-36 Software Configuration 80
- 3-38 Software Configuration 82
- 3-40 Software Configuration 84
- 3-42 Software Configuration 86
- Specifications 87
- Short-haul MTRJ 88
- Pin 1 Pin 5 90
- Pin 6 Pin 9 90
- Pins not shown are unused 96
- RX In TX Out 99
- G.703 Balun 99
- Model 460 MC 99
- Regulatory/Safety Compliance 101
- ALARM LOS 101
- ENABLE LOF 101
- Port 0 Activation LED 102
- Port 1 Activation LED 102
- Pin 8Pin 1 102
- Transmit Pair Termination 103
- Port 0 Port 1 103
- Port 1Port 0 103
- Receive Pair Termination 103
- NIM1 NIM2 107
- LED State Function 108
- Index-2 110
Relacionado con productos y manuales para Hardware Enterasys-networks XSR-3020
Hardware Enterasys-networks FN 100 Manual de usuario
(54 paginas)
(54 paginas)
Hardware Enterasys-networks XSR-3150 Manual de usuario
(110 paginas)
(110 paginas)
Hardware Enterasys-networks 802.1Q Manual de usuario
(82 paginas)
(82 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.080 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales