Enterasys-networks BRIM-E6 Manual de usuario descargar pdf (Pagina 19)

BRIM-E6 USER’S GUIDE Page 13

CHAPTER 3

CONNECTING TO THE NETWORK

This chapter outlines the procedure for connecting the BRIM-E6 to a

network.

3.1 CONNECTING THE BRIM TO THE NETWORK

The procedure for connecting network segments to the BRIM-E6 depends

on which EPIM you install. Refer to the following list and perform the

procedure described in the subsections that apply to your conﬁguration:

• EPIM-T 3.1.1

• EPIM-F1, F2, F3 3.1.2

• EPIM-C 3.1.3

• EPIM-A 3.1.4

• EPIM-X 3.1.5

Prior to connecting the network cabling check the connectors for the

proper pinouts as shown in Appendix A.

3.1.1 Connecting a UTP Segment to an EPIM-T

Before connecting a segment to the EPIM-T, check each end of the

segment to determine if the wires have been crossed-over for the proper

connection. If the wires do not cross over, use the switch on the EPIM-T

to internally cross over the RJ45 port. Refer to Figure 3-1 to properly set

the EPIM-T cross-over switch.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 40 41

Sin comentarios

Enterasys-networks BRIM-E6 Manual de usuario Pagina 19