Enterasys-networks BRIM-E6 Manual de usuario descargar pdf (Pagina 28)

BRIM-E6 USER’S GUIDE Page 23

CHAPTER 4

USING THE LANVIEW LEDS

This chapter describes how to use the LANVIEW Diagnostic LEDs to

monitor BRIM status and diagnose BRIM problems.

Figure 4-1. LANVIEW LEDS

4.1 STB (Standby)

• On - The bridge port is in the non-forwarding state. Possible causes

of this condition are: redundancy detected by Spanning Tree, data

link layer down, physical layer down, or port disabled.

• Off - The bridge port is in the forwarding state.

4.2 XMT (Transmit)

• On - The BRIM is transmitting packets.

• Off - No activity.

4.3 CLN (Collision)

• On - A collision has occurred on the BRIM port.

• Off - No activity.

4.4 RCV (Receive)

• On - The BRIM port is receiving packets.

• Off - No activity.

BRIM-E6

STB

RCV

CLN

XMT

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 40 41

Sin comentarios

Enterasys-networks BRIM-E6 Manual de usuario Pagina 28