Enterasys-networks X-Pedition 2000 Manual de usuario descargar pdf (Pagina 44)

Installing the Hardware

28 Enterasys Xpedition 2000 Getting Started Guide

Connecting Power to the Chassis

To attach the unit to AC power, simply plug the chassis into a grounded power source. For

information about the AC power requirements, see Hardware Specifications on page 24.

To attach the unit to the DC power supply, connect the ground, negative, and positive leads to their

respective terminals at the rear of the unit. For information about the DC power requirements, see

Hardware Specifications on page 24.

Installing an Expansion Module

Warning: Before performing any upgrade or installation procedures, ensure that the

XP-2000 is powered off and that you are properly “grounded” to avoid electrostatic discharge

while working inside the XP-2000’s chassis.

Note: A hardware restriction prevents the Xpedition 2000 from supporting configurations

consisting of:

– Two (2) 1000Base-SX or 1000Base-LX Gigabit modules.

– Two (2) 100Base-FX modules.

However, the router does support a configuration consisting of one (1) Gigabit module and

one (1) 100Base-FX module.

To install a 1000BASE-SX or 1000BASE-LX gigabit expansion module:

1. Ensure that the XP-2000 is powered off.

2. If your XP-2000 is equipped for rack mounting, use the phillips-head screwdriver to remove

the mounting brackets from each side of the XP-2000.

3. Take off the XP-2000’s top cover.

a. Use the phillips-head screwdriver to remove the four mounting screws (two on each side

of the router, front and back) that hold the top cover on the XP-2000.

Figure 10. Removing the XP-2000’s cover

87654321 87654321

CONSOLE

10/100 MGMT

ERR DIAG

HBT

RST

10/100BASE-TX 10/100BASE-TX

SYS

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 85 86

Sin comentarios

Enterasys-networks X-Pedition 2000 Manual de usuario Pagina 44