Enterasys-networks X-Pedition 2000 Manual de usuario descargar pdf (Pagina 48)

Installing the Hardware

32 Enterasys Xpedition 2000 Getting Started Guide

• An RJ-45 10/100Base-T DTE port for Telnet connection from a host on the network. The port

is configured for Media Data Interface (MDI). You use this port to manage the XP-2000 using

the CLI or SNMP.

Connecting to the Serial Port

Figure 16 shows where to plug in the cable to the XP-2000’s serial port. The procedure following

the figure describes how to set up and insert the cable.

Figure 16. Plugging into the XP-2000’s serial (DB-9 DCE) port

To attach the supplied console cable to the XP-2000’s DB-9 port:

1. Locate the console cable included with the XP-2000 chassis. The console cable is a female to

female DB-9 crossover cable that has the following pin assignments:

87654321 87654321

1000BASE-SX

87654321

10/100BASE-TX

CONSOLE

10/100 MGMT

ERR DIAG

HBT

RST

G2M-HTXA2-08 G2M-GSXA1-02

10/100BASE-TX 10/100BASE-TX

Link

SYS

Table 16. DB-9 connector pin assignments

Signal (XP-2000 port) Pin Signal (management console port)

Unused 1 Unused

TXD (transmit data) 2 RXD (receive data)

RXD (receive data) 3 TXD (transmit data)

Unused 4 Unused

GND (ground) 5 GND (ground)

Unused 6 Unused

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 85 86

Sin comentarios

Enterasys-networks X-Pedition 2000 Manual de usuario Pagina 48