Enterasys-networks X-Pedition 2000 Manual de usuario descargar pdf (Pagina 77)

Enterasys X-Pedition 2000 Getting Started Guide 61

Activating Configuration Changes and Saving the Configuration File

Activating the Configuration Commands in the Scratchpad

The configuration commands you have entered using procedures in this chapter are in the

Scratchpad but have not yet been activated. Use the following procedure to activate the

configuration commands in the scratchpad:

1. Ensure that you are in Enable mode by entering the enable command in the CLI.

2. Ensure that you are in Configure mode by entering the configure command in the CLI.

3. Enter the save active command.

If you exit Configure mode (by entering the exit command or pressing Ctrl+Z) before activating

any of your changes in the scratchpad, the CLI will ask you whether you want to make the

changes in the scratchpad active by displaying the following message:

4. Enter yes or y to activate the changes.

Saving the Active Configuration to the Startup Configuration File

After you save the configuration commands in the scratchpad, the XP-2000 executes the commands

and makes the corresponding configuration changes. However, if you power down or reboot the

XP-2000, the new changes are lost. Use the following procedure to save the changes into the

Startup configuration file so that the XP-2000 reinstates the changes when you reboot the firmware.

1. Ensure that you are in Enable mode by entering the enable command in the CLI.

2. Enter the copy active to startup command to copy the configuration changes in the Active

configuration to the Startup configuration.

The CLI displays the following message:

3. Enter yes or y to save the changes.

Note: You also can save active changes to the Startup configuration file from within Configure

mode by entering the save startup command.

The new configuration changes are added to the Startup configuration file stored in the XP-2000’s

boot flash.

Viewing the Current Configuration

If you want to view the current configuration:

Do you want to make the changes Active [yes]?

Are you sure you want to overwrite the Startup configuration [no]?

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 85 86

Sin comentarios

Modely	Typ Dokumentu
SAL24N	Uživatelský manuál AUTOMATIC LEVEL MANUAL, 26 stránky
SAL28N	Uživatelský manuál rotary laser accessories, 40 stránky Uživatelský manuál Catalogue, 63 stránky
SAL32N	Uživatelský manuál Equipment for Contractors, Surveyors, and Engineers, 8 stránky

Enterasys-networks X-Pedition 2000 Manual de usuario Pagina 77