Enterasys Networks CSX7000 Manual de usuario descargar pdf (Pagina 443)

100

101

Central Site Remote Access Switch 443

ERIFYING

OUTING

ROTOCOLS

IP Routing Operational?

3. Determine if a local IP Host A has learned the route to 192.1.1.0 from System A. On IP Host A

type:

netstat -r

If the route to 192.1.10 is displayed, the IP RIP output processing is operational.

4. If the route is NOT displayed, try the following:

a. Using the

ipnetif

Manage Mode command, verify that the IP RIP Send Control is set to

a RIP version that the IP Host can understand.

b. If the command shows Do Not Send, the IP RIP output processing is disabled on the

interface. Correct the RIP Send Control configuration using CFGEDIT.

c. If the command shows an improper version of RIP, correct the RIP Send Control to the

proper RIP version that the IP Host can understand.

5. Enter the

ip rip stats

administrative console command. Look for the

IfStatSentResponses counter for the interface, which shows the number of RIP update

messages sent on the interface.

a. If the counter is 0, enter the

ip rip send

administrative console command to force the

RIP update message to be sent immediately.

b. Reissue the

ip rip stats

command.

c. If the counter is still 0, there is an unexpected condition present within the CyberSWITCH

software. Contact Customer Support.

6. If the RIP Send Control is set to “RIP Version 1” or “RIP Version 1 Compatibility,” use Manage

Mode to verify that the transmit broadcast address on the interface is set to a proper address

that the IP Host can receive (through issuing the

ipnetif

Manage Mode command).

7. If the transmit broadcast address is not set properly, use CFGEDIT to correct it.

8. Check the IP Host and ensure that it is set up to learn route information via RIP.

IP RIP INPUT PROCESSING ON A LAN INTERFACE

To verify that IP RIP Input Processing (routes learning) is properly operational on a LAN interface,

IP RIP processing must be successfully initialized. Also, a local IP router must be connected to the

local LAN port on the system and capable of propagating routes information via RIP.

Below is an example of a configuration used to verify IP RIP input processing on a LAN interface.

It uses IP addresses specified to the example. Substitute the IP addresses of your network when you

perform the verification steps. It also uses the

netstat

command. The

netstat

command

displays the IP routing table of the system. Substitute the equivalent command on your IP router.

1 2 ... 438 439 440 441 442 443 444 445 446 447 448 ... 728 729

Comentarios a estos manuales

Sin comentarios

Enterasys Networks CSX7000 Manual de usuario Pagina 443

Comentarios a estos manuales