Enterasys-networks BRIM-E6 Manual de usuario descargar pdf (Pagina 24)

CHAPTER 3: CONNECTING TO THE NETWORK

Page 18 BRIM-E6 USER’S GUIDE

2. If the Internal Termination switch is in the On position, connect the

thin-net segment directly to the BNC port as shown in

Figure 4-3.

3. If the Internal Termination switch is in the Off position:

a. Attach a BNC tee-connector to the BNC port on the module.

b. Attach the thin-net segment to one of the female connectors on

the tee-connector.

Note: You must terminate each segment attached to the tee-connector. If

you do not attach a segment to one of the female connections on the

tee-connector, then a terminator must be placed on that connection.

c. Attach another thin-coax segment or a terminator to the other

female connector on the tee-connector.

Figure 3-3. The EPIM-C

Attach thin-net segment directly to BNC

connector when internal termination

switch is set to on ( ).

When internal termination switch

is set to off ( ):

Connect BNC tee-connector to port.

Attach a terminator or terminated

thin-net segment to one female

connector of tee-connector.

Connect a terminated thin-net

segment to other female connector

of tee-connector.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 40 41

Sin comentarios

Enterasys-networks BRIM-E6 Manual de usuario Pagina 24